X-Sense Link+ Wireless Smoke and Carbon Monoxide Detector Alarm Remote Controller (1-Pack)

Revised Content:

Effortlessly Pair the Remote Controller with X-Sense Alarms

1. Press the test/silence button on one of the interconnected detector group 4 times. The unit will emit a single beep, and the red LED will flash slowly, indicating it is ready to add a new unit.
2. Press the test/silence button on the remote controller twice. The LED will flash rapidly, signaling it is searching for a device to connect.
3. After successful pairing, the alarm will beep once and automatically exit the pairing mode.

Seamless Wireless Alarm Verification

1. Hold the test button while within wireless range. The LED indicator on the remote controller will flash.
2. Once the alarms receive the signal (approximately 7 seconds), their LED indicators will flash, and the alarms will sound continuously.
3. Release the test button. The LED indicator on the remote controller will stop flashing, confirming the test is complete.

Effortless Alarm Silencing

Simply press the test button to silence the alarms when non-emergency smoke (e.g., steam) triggers nuisance alarms. During an alarm, press the button once, and all the interconnected alarms except the initiating alarm will be silenced. Press again to silence the initiating alarm. The LED indicator on the remote controller will blink blue with each press.

Verify Remote Controller's Power Status

In standby mode (non-alarming state), when you press the test button, the LED indicator on the remote controller will blink blue, indicating a normal power supply.

Seamless Battery Installation

1. Pry open the rear cover by inserting the included key into the slot at the bottom of the remote controller's backside.
2. Peel off the insulating film on the button cell. Ensure the correct polarity of the battery and close the cover.

The revised content maintains the original meaning while enhancing the reading experience through improved sentence structure and flow. The word count remains within the 500-word limit.

product information: